Ready to ship, no wait!
This machine has barely been used at all. Not much more than the demo phase when I purchased it last october. I have the finger bit shown in the picture with a couple extra diamond fingers for cutting. I have 9 different grit antiquing brushes, and a couple of templates for pelican bathroom sinks.
The sturdy yet agile Fab King Fabrication Center is engineered for efficiency, simplicity and reliability to ensure profitability for its users. The Fab King fabrication center utilizes the a 3HP motor on a rigid cantilever frame. This system allows for the use of Master/Sector tooling for edge profiling and also increases the router travel to 9-� feet. The Fab King requires little or no experience to operate. The Fab King can cut out any sink shape using a template (which means no mistakes and precise dimensions) in as little as 8 minutes. It can drill utility holes in seconds with minimal tool wear. Edge profiling is quick and easy with no threat of scratching the surface. Gantry movement insures smooth travel for the X and Y axis. Other features of the machine include surface polishing and honing, and back-splash polishing.
220 Volt Single phase.
3 HP motor
114 inch X-axis travel, 30 inch Y-axis travel, and 8 inch Z-axis travel.
Variable speed 2,700 ñ 10,000 RPM
Dust free operation.
Center & halo water feed
Precision control raise/lower with friction brake.
3 point adjustable work surface.
Installs in minutes.
� Gas water feed
Heavy duty spindle bearing for long life
Water consumption 2 gallons per minute, ideally below 10 microns purity.
Weight: 1,520 lbs.
Dimensions: 11í 9" L x 5í 11" H x 3í 8" W