20 HP Saw motor
Here are some photos of our saw. It is a 2000 model Matrix GSC-2000. It is in good working order and is used daily. It has a rotating table, the secondary table lock is broken but we just use a couple of clamps. The main lock that stops a 0,45,90 works. It has a 20hp Saccardo sawing motor and we are the original owner of this saw. It will be in operation daily until late February when our new CNC saw arrives, so it will not be available until then. We are glad to accommodate buyers that would like to see the saw in operation up until we have to take it down. The saw is set to 208/230 3 phase.
(THIS SAW HAS SLAB LOAD ASSIST BARS
THE TABLE DOES NOT TILT)
14" - 26" blade diameter
Arbor Shaft Style (50 mm diameter)
138" Saw bridge cut capacity, cutting Stroke
17' Saw bridge overall length
Saw bridge feed 1/2 H.P. Motor with Variable Speed Control
Specification; Tilt, 0-45 degrees
Gantry bridge feed 1/2 HP Motor with Variable Speed Control
Vertical travel 10" Stroke Length
Vertical travel feed 1 /4" H.P. Motor with variable speed control
Adjustable Travel Limit Switch Control.
10' x 6' Rotary saw table, 360 degree rotation.
Table position locks at the following increments: 0, +45, +90, +180 and at any angle brake.
9" X 7" Rectangular Steel Construction.
Precision Ground Steel Guideways.
1- 1/4" x 8" Precision Steel Guide ways, Ball Screw Drive.
Power requirements 30 VAC, 3 Phase, 60 Amps.
Complete with: Laser, digital read out (D.R.O) water on /off switch, remote control for all 3 axis, and e-z load slab arms for loading slabs on table.
MADE IN USA!
Parts and service for this machine are available.